Description:  One component, flexible cementitious mortar for waterproffing and protection of concrete structures, renders and cementitious screed against water and humidity.

Binder:  Portland Cement

Aggregate:  0-0.5mm

Appearance:  Gray powder

Mixing Ratio:  0.3-0.35 it water/ 1kg powder

Performance Data: 

       Flexural strength ≥ 10N/mm

       Compressive Strength ≥ 30N/mm

       Waterproofing Capacity (for 3 mm thickness): ≥ 1 bar (positive)

       Tensile Strength (EN 1542): ≥1.00 N/mm

Packaging:  Packed in 1 KG plastic lined paper sacks

Storage:  Store in dry medium. Do not stack more than 10 bags on top of each other.

Pot life:  1 hour

Shelf Life:  12 months when stored in the orignal sealed packing in dry place

Ready to Use:  7 days 

Waiting Time Between the coats: 5-6  hours 

Grouting: 8 hours on wall; 24 hours after on floor

Application Temperature Range:  (+5°C) - (+35°C)



     The substrate must be solid, dry, free of dust, loose parts, paint, wax, oil, rust and traces of gypsum. Cementitious substrates must be cured. Use Yapfix Repairing Montar in case of any loose and uneven substrate to get a sound and flat surface.

     The substrate should be protected from sunlight, precipitation and dust for 1 day and application should not be under direct sunlight. Dampen absorbent surfaces to be treated beforehand with water.


     Pour 0.3 - 0.35 liters of water for application with brush of 0.2 - 0.25 liters of water for application with roller and trowel into a suitable clean container.

    The slowly add 1 kg powder component and mix with a low speed mixer to obtain a homogenous lump free mix. Mixing with max 500 rpm mixer is recommended.

Allow to stand for 5 minutes to mature. After remixing for 1-2 minutes, the paste is ready for application.


     Apply a thing layer of YAPFIX waterproofing with brush, roller or trowel, then after 5-6 hours apply a second coat, to have a final thickness of approximately 2-3 mm in the product application instructions insert a 4.5x4 mm mesh in the first layer of Yapfix waterproofing when operation around expansion joints between horizontal and vertical surfaces, areas with small cracks or places subjects to stress.

   After the mesh has been lain apply a second layer of Yapfix waterproofing when the first one has set (after 5-6 hours) Use Yapfix Waterproofing within 1 hour of preparation. Unfavourable climatic conditions (high temperature, low humidy , wind etc) can reduce this time to just a few minutues.

Dispose mortars of which pot life is expired. clean tool and hands with a damp cloth.

  • Easy to apply either by brush, roller or trowel.
  • Excellent bonding on all concreate and masonry.
  • Provides increase water repellency.
  • Reduces water absorption.
  • Non- corrosive for steel and construction elements.